15JF-25S
ELECTRICAL SPECIFICATIONS
"Power Input .................... 220V-240 Volts AC 50Hz"Sweep Deflection ..................................... Magnetic
"Picture Intermediate frequency ................. 38.9 MHz
"Power Consumption
Normal Operation (Method IEC60107) ............ 37W"Sound Carrier Trap .................................. 33.4 MHz
Stand-by Operation ............................................ 3W
"Adjacent Sound Carrier Trap ................... 40.4 MHz
"Adjacent Picture Carrier Trap ................. 31.9 MHz
"Audio Power Output Rating ........................ 2 W (MPO).
Speaker .............................. 16&, 4W, 9 x 5 cm, 1pc"Aerial Input Impedance
VHF/UHF ...................... 75 ohm Unbalanced
"Convergence ............................... Self Converging System"Tuning Ranges........... 48.25 MHz thru 855.25 MHz
VHF: CH02 - CH12
S1 - S41 (Hiperband)
"Focus ....................... High Bi-Potential ElectrostaticUHF: CH21 - CH69 CH
"White Level
Set brightness control to get total picture tube cathode current of 1000 ?A under no signal condition.
Maximum necessary correction of each picture tube cathode current to get 8550 degrees K+1 MPCD
screen temperature should not exceed 15% of its original value.
X=0.290 ? 0.015 Y=0.300 ? 0.015
Specifications are subject to change without prior notice.
MODEL DESTINATION (Operation Manual languages)
15JF-25S: Deutsch, Nederlands, Français.
15JF-25SIT: Italiano.
WARNING
The chassis in this receiver is partially hot. Use an isolation transformer between the line cord plug
and power receptacle, when servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel.
3 |