25N-M100/M180/S100/S180
CN25M10,CN25S18/20
DESCRIPTION OF SCHEMATIC DIAGRAM
HNOTES:WAVEFORM MEASUREMENT CONDITIONS:
1. The unit of resistance "ohm" is omitted.1. Photographs taken on a standard gated color bar
(K=k& =1000& , M=M& )signal, the tint setting adjusted for proper color. The
2. All resistors are 1/16 watt, unless otherwise noted.wave shapes at the red, green and blue cathodes of
3. All capacitors are ? F, unless otherwise noted.the picture tube depend on the tint, color level and
(P=pF=??F)picture control.
4. (G) indicates ?2% tolerance may be used.2. indicates waveform check points (See chart,
waveforms are measured from point indicated to
5. indicates line isolated ground.
Gchassis ground.)
VOLTAGE MEASUREMENT CONDITIONS:
1. All DC voltages are measured with DVM connecteda AND SHADED ( ) COMPONENTS
between points indicated and chassis ground, line= SAFETY RELATED PARTS.
voltage set at 120V AC and all controls set for normal'MARK= X-RAY RELATED PARTS.
picture unless otherwise indicated.
2. All voltages measured with 1000? V B & W or ColorDRGANNES MARQUES a ET HACHRES ( ):
Fsignal.PIECES RELATIVES A LA SECURITE.
MARQUE ' : PIECS RELATIVE AUX RAYONS X.
This circuit diagram is a standard one, printed circuits
may be subject to change for product improvement
without prior notice.
E
WAVE FORMS
D
C
B
A
123456
21 |
ACEC
