29A-SX1
29A-SX5
29A-SX8
SX-68JF200
" KEY
DOWN"4" KEYDOWN"5" KEYDOWN"6" KEYDOWN"DOWN"0" KEY
Y : 0.275
KX : 0.272
°the signal generator for adjustment.use "SX-1006"
On the monocolour screen of white or greenthe shipment initial setting table.
Note 1 : R CUT OFFUP"1" KEYG CUT OFFUP"2" KEYB CUT OFFUP"3" KEYData up/down is possible with the above comparison.*12300 (With Minolta colour thermometer CA-100)Note 1 : G-DRIVEUP"7" KEYB-DRIVEUP"8" KEYData up/down is possible with the above comparison.*The colour temperature is based onNote 2 :Use the window pattern of(PAL and colour burst are present.)Note 3 :Signal generator of 2-1, 2-2
A
m
A or 50
m?
50
?
13
the beam current 1,500 more for 30 minutes or more.with the beam current 1,500 or more for 30 minutes or more. (On the white or green monocolour screen)
and subsequence above. (12,300K)
5
Receive E-5CH (Monoscope pattern).Select P-NORM with the remote controller.Turn on the service SW, and select the CUT OFF BKGD mode.Select the screen VR 0/10.Press O-/--� key of the remote controller to se- lect the lateral in-line mode.Turn the screen VR clockwise, and adjust the first lighting lateral in-line raster to slightly light.Adjust the CUT OFF data of two other colours, and coarsely adjust the lateral in-line to become white. (Note 1)Turn the screen VR in the opposite direction to the point where the lateral in-line raster goes out. Note 1:Apply the adjustment after aging withPress O-/--� key of the remote controller to se- lect the normal mode.E-5CH (Monoscope pattern) is received.Select P-NOM with the remote controller.Connect the beam ammeter between TP1601 and TP1602.Coarsely adjust the beam current to approx. 1.7 mA with R1633 (sub-contrast VR).Receive the window pattern with AV input. (PAL burst is generated with the signal generator.)With the data of G-drive and B-drive, adjust the colour temperature 12,300K of the white peak to white.Adjust the right dark area of the window to 12,300K with R-cut off, G-cut off and B-cut off.Readjust the colour temperature at the white peak.Check 12,300K at the low white. Note 1 :Apply this adjustment after agingThe window pattern is received with DVD sig- nal (component signal).Apply the adjustment in the same manner as 2-1(G-DRIVE, B-DRIVE, R-CUTOFF, G-CUT- OFF, B-CUTOFF) Apply the adjustment after the end of 2-1.
1234590qw12345678912
CUT OFF, BKGD ADJUSTMENT METHOD
CRT CUT OFF Service mode2IC bus dataadjustmentWhite balance background2IC bus adjust-ment (RF Signal)* White balance background2IC BUS adjust-ment (DVD signal)
1
NO.Adjustment partAdjusting procedure and conditionsWaveform and others2-12-2
13 |
ACEC
