32LW-92H
ELECTRICAL SPECIFICATIONS
"Power Input .................... 220V-240 Volts AC 50 Hz"Picture Intermediate frequency ......... 38.9MHz
"Sound Carrier Trap ........................... 32.9MHz
"Power Consumption
Normal Operation (Method IEC60107) ............... 90 W"Adjacent Sound Carrier Trap ............. 40.9MHz
Stand-by Operation .......................................... < 4 W
"Adjacent Picture Carrier Trap ........... 30.9MHz
"Audio Power Output Rating (MPO) / Impedance
Internal Left Speaker ................................. 10 W, 8 &"Aerial Input Impedance
Internal Right Speaker ............................... 10 W, 8 &VHF/UHF ................. 75 ohm Unbalanced
"Tuning Ranges ..... 45.75MHz thru 855.25 MHz
"Speakers
2 ways speaker elliptic (2 pcs) ............ 42 x 180 mmVHF: IR A - J / CC01-CC68 (Hiperband)
UHF: I21 - I69 CH
Tweeter (2 pcs) ................................................... 27mm
"Convergence (Maximum Misconvergence)
AREA32? Wmm
A0.4
BC1.4
DE1.0
FGHJ1.8
KLMN1.6
F?G?H?J?1.6
STUV1.4
"White Level
Apply the rated voltage at the rated frequency to the TV set, while it is receiving full white pattern RF signal of 60
dB/?V from its RF input via the pattern generator.
Turn all picture controls to maximum value. Measure the colour temperatures at the center of the screen by
using the colour analyzer.
X=0.290 ? 0.015 Y=0.284 ? 0.015
Specifications are subject to change without prior notice.
WARNING
The chassis in this receiver is partially hot. Use an isolation transformer between the line cord plug
and power receptacle, when servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel.
3 |
ACEC
