37GT-25H
PAGEADDRESSDESCRIPTIONVALUE
1C410
C502
C6PAGE MEMORY FOR LIST MODE PROGRAM 600
C730
C804
C900
CA10
CB02
CCPAGE MEMORY FOR LIST MODE PROGRAM 700
CD30
CE04
CF00
D0 < FFRESERVEDFF
DEFAULT LIST MODE PAGES MEMORIZATION NOTE:
In page memory for LIST MODE, every digit is written in one nibble (4 bits).
The default values for programs 0<7 are as follows: 100, 200, 300, 400.
Example: Program 0
NVM Position: A0 A1 A2 A3 A4 A5
NVM Value:{ {{{{{{{{{{{
100200300400
{{{{
Page 100Page 200Page 300Page 400
"""""PIF/AGC Adjustement"""""Screen Adjustement
1. AFT Adjustment3. Focus Adjustment
AFT must be adjusted to a fixed value of 40.Apply mains voltage of 220V AC/50HZ to TV.
1.
2. Receive Philips pattern signal to a level between
60 and 80 dB?V.
3. Set contrast to 10/10, brightness to 5/10 and
colour 0/10.
4. Adjust focus potentiometer to obtain
maximum definition.
2. RF-AGC Cut-In Adjustment (I2C BUS)4. G2 Adjustment
1. Receive the ?COLOUR BAR? signal (Channel E-1.Apply mains voltage of 220V AC/50HZ to TV.
12). Signal strength: 53 dB?V.
2. Receive the ?MONOSCOPE? pattern signal to a
2. Enter into Service Mode.level between 60 and 80 dB?V.
3. Push CH ' until AGC appears on screen.3.Enter into Service Mode. Press the TEXT key of
R/C and set to level.
4 Push key of R/C.Setting is made.
automatically. During this setting the colour bar4.Set to the point where the raster disappears on
shall go from red to yellow. When setting isthe screen VR of FBT.
finished, colour bar disappears and B-STOP
(bus stop)is shown on screen.5. Check BKGD. If it is necessary adjust BKGD
according to instructions detailed in the next
5. Switch set OFF and ON again, setting is now page.
memorized.
8 |
ACEC
