51GT-25H
ELECTRICAL SPECIFICATIONS
"Power Input .......................220V-240 Volts AC 50Hz"Sound Carrier Trap.............................32.9MHz
"Power Consumption
Normal Operation....................................52W
"Adjacent Sound Carrier Trap................40.9MHz
Stand-by Operation.................................7.0W
"Audio Power Output Rating .....................4W (MPO)"Adjacent Picture Carrier Trap...............30.9MHz
Speaker..........................16& 4W, 10cm Round, 1pc
Convergence.........................Self Converging System"Aerial Input Impedance
Focus....................................Bi-Potencial ElectrostaticVHF/UHF...........................75 ohm Unbalanced
Sweep Deflection...........................................Magnetic
"Tuning Ranges ............471.25MHz thru 855.25 MHz
"Picture Intermediate Frecuency..............38.9MHz (CH21-CH69)
"White Level
Set the brightness control, with no signal connected, so that the CRT cathode current is 600mA. The maximum
correction applied to each cathode current to achieve a screen temperature of 8950 degrees K-20 MPCD should
not exceed 15% of its original value.
X=0.290 Y=0.284
Specifictions are subject to change without prior notice.
WARNING
The chassis in this receiver is partially live, always use an isolation transformer when
servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer
servicing to qualified service personnel.
3 |
ACEC
