70GS-66E
ELECTRICAL SPECIFICATIONS
"Power Input ...................... 220V-240 Volts AC 50Hz"Sweep Deflection ............................... Magnetic
"Picture Intermediate frequency
"Power ConsumptionL?......................................................33.9MHz
Normal Operation ...................................88WL, B/G, D/K, I...............................38.9MHz
Stand-by Operation ..................................1W
"Sound Carrier Trap
L?..................................................40.4MHz
L, D/K...........................................32.4MHz
"Audio Power Output Rating (MPO) / ImpedanceB/G..............................................33.4MHz
Internal Left Speaker ...................... 10W, 7&I....................................................32.9MHz
Internal Right Speaker .................... 10W, 7&
"Adjacent Sound Carrier Trap
Internal Centre Speaker .............. 10W, 7&
L?..................................................32.4MHz
Internal Subwoofer .................... 20W, 4.5&
L, D/K, B/G..................................40.4MHz
I....................................................40.9MHz
"Adjacent Picture Carrier Trap
"SpeakersL?..........................................................41.9MHz
Left / Right ...............................12W, 6 x 12cmL, D/K, I........................................30.9MHz
Centre .....................................12W, 6 x 12cmB/G..............................................31.9MHz
Subwoofer .........................20W, 11cm Round
"Aerial Input Impedance
"ConvergenceVHF/UHF ................. 75 ohm Unbalanced
Static (Centre) .. between any two colours
Dynamic .............. after static equals zero"Tuning Ranges ..... 45.75MHz thru 855.25 MHz
"Focus ................ High Bi-Potential ElectrostaticCATV Special Channels
"White Level
Set brightness control to get total picture tube cathode current of 600 milliammeter under no signal
condition. Maximum necessary correction of each picture tube cathode current to get 8550 degrees K+1
MPCD screen temperature should not exceed 15% of its original value.
X=0.290 Y=0.300
TENTATIVE
Specifications are subject to change without prior notice.
WARNING
The chassis in this receiver is partially hot. Use an isolation transformer between the line cord plug
and power receptacle, when servicing this chassis.
To prevent electric shock, do not remove cover. No user-serviceable parts inside. Refer servicing to
qualified service personnel.
3 |
ACEC
