PC-UM10M
2. OPERATION FOR THE FRONT COVER3. MANUAL PAPER FEED FROM
OPENBYPASS TRAY
When the user opens the cover, perform the following procThe basic procedureedure of manual paper feed is as follows:
depending on the condition.1. When the user manually inserts a paper into the specified position
for manual paper feed, the paper empty sensor (hereinafter referred
During power ON initializing (From the power switch ON toto as PE sensor) turns OFF (paper presence) and the paper LED
the completion of power ON initializing):blinks.
Interrupt power ON initializing, move the carriage to the mainte-
nance position, and perform power OFF initializing.Next, when the user presses the resume button, the paper is fed by
When the cover is closed, perform power ON initializing.about 6mm and is fixed. Then manual paper feed is possible.
2. Since paper is not fixed under that state, if the user let go of the
paper, the paper will come off from the manual paper feed position.
Therefore, when the paper presence state is kept for a certain time
(10 sec), paper is fed by 6mm to fix the paper. Then manual paper
feed is allowed.
During paper feed:
Continue paper feed operation. After completion of paper feed3. To start printing, feed paper from the manual paper feed position.
operation, perform the same procedure as those of cover open dur-The following operations are the same as normal printing.
ing printing.
4. If the user removes paper before paper feed, manual paper feed is
During printing (From paper feed to paper exit):canceled and the state returns to "1".
Move the carriage to the maintenance position. If printing is being
performed, after completion of one pass printing, move the carriage
to the maintenance position. When the cover is closed4,. pr iOUTLnting isINE OF PROCESS FOR
resumed.
MAINTENANCE
Non-printing (with no paper fed):
A. CAP ENTRY PROCESS
1. Move the carriage to the center (the ink cartridge replacement posi-
tion).Perform the following procedures to cap the head for standby.
1. Move the carriage to the maintenance position.
2. Rotate the maintenance motor, and wipe the head with the wiper.
2. When the cover is closed with the print head installed, or when a
certain time is passed with the cover opened, move the carriage to
the maintenance position. (If the print head is not installed, the car-
riage is not returned to the maintenance position though the cover
is closed.)
3. The presence of an Ink cartridge is sensed.
4. When the ink cartridge is replaced, prime operation after replace-
ment of the ink cartridge is performed.
AJ-6110 OPERATIONAL DESCRIPTIONS
6 - 3 |
ACEC
