63 -07Operation/1. Set the SIT chart (UKOG-0280FCZZ) on the
Proceduredocument table, and make a copy in the manual
PurposeSettingphoto mode.
Function Used to set the target color balance (gamma) for
2. Set the copied SIT chart on the document table.(Purpose)auto color balance adjustment. The standard color
3. Enter the simulation 63-9 mode.
balance (gamma) or an optional color balance
4. Press the [EXECUTE] key.(gamma) is set as the service target.
The color coefficient automatic adjustment pattern reading is SectionImage process (MFP)
started to calculate and display the color coefficient data. The
ItemPicture qualityColor balancecolor coefficient data of each color can be displayed with the color
Operation/ 1. In the copy color balance adjustment (manual key.
Procedureadjustment) (SIM 46-21) mode, the color patch
image (adjustment pattern) is outputted. (This
must be adjusted properly.)
2. Press the [SETUP] key.
3. Set the color patch image (adjustment pattern) paper printed in
the copy color balance adjustment (manual adjustment) (SIM
46-21) mode on the document table.
4. Press the [EXECUTE] key. The color patch image (adjustment
pattern) is read.
5. Press the REPEAT key and perform procedure 4 again.63 -10
6. Press the [OK] key.
The color balance corresponding to the color patch image PurposeSetting
Function Used to set the copy document mode color balance
(adjustment pattern) printed in the copy color balance adjustment (Purpose)(gamma) default.
(manual adjustment) is set as the service target.
SectionScanner (Image scanning)
ItemPicture qualityColor balance
Operation/1. Press the [EXECUTE] key, and the [YES] and
Procedure[NO] keys become active.
2. When the [YES] key is pressed, the color balance value is set
to the default.
63 -08
PurposeSetting
Function Used to set the service target of the automatic color
(Purpose)balance adjustment (SIM 46-24) and the automatic
color balance adjustment target of the key operator
program to the same balance as the factory target of
the automatic color balance adjustment (SIM 46-24).63 -11
SectionScanner (reading)
PurposeSetting
ItemPicture qualityColor balanceFunction Used to set the factory color balance in the
Operation/1. Press the [EXECUTE] key.(Purpose)automatic color balance adjustment (SIM 46-24).
Procedure2. Press the [YES] key. SectionScanner (reading)
With the above procedures, the service target of the
automatic color balance adjustment (SIM 46-24) and ItemPicture quality
the automatic color balance adjustment target of the Operation/There are three kinds of color balance targets.
key operator program are set to the same level as ProcedureSelect an optional color balance target.
the factory target of the automatic color balance This setting is applied to the factory target only.
adjustment (SIM 46-24).
DisplayContentNOTE
DEF1Color balance with emphasis on color Default
reproduction (factory setting)
DEF2Color balance with slightly strong Cyan
DEF3Color balance with emphasis on Cyan
63 -09
PurposeSetting
Function Used to adjust the CCD gamma (CCD calibration)
(Purpose)(copy document mode).
Note: When this simulation is executed, SIM 63-8 should be exe-
cuted after that.SectionScanner (reading)
ItemPicture qualityColor balance
AR-C172M SIMULATION 9 - 64 |
ACEC
