5) Disconnect the three connectors [7].(6) Paddle Assembly
6) Release the two claws [8] of the harness retainer, and detach1) Remove the processing tray assembly. (See B.(3).)
the motor harness [9].2) Place the processing tray assembly [1] as shown.
NOTE: Be sure to take care not to damage the aligning plate
[2].
[1]
[9]
[2]
3) Detach the timing belt [3], and remove the two screws [4].[8]
[7][4]
7) Remove the stop ring [10], and detach the timing belt [11].
8) Disconnect the connector [12], and free the harness [14] from
the edge saddle [13].
[12]
[11][14]
[3]
[10]
[13]
9) Remove the two screws [15], and slide the processing tray
assembly [16] to the rear; then lift it to detach.
[4]
4) Separate the processing tray assembly [5] and the paddle
assembly [6] as shown.
[16][6]
[5]
[15]
MX-FNX2/AR-PN1/MX-RBX1 DISASSEMBLY AND ASSEMBLY 6 - 6 |
ACEC
