AY-XM7/9/12CR
AY-XPM7/9/12CR
AE-XM18/24CR
How to remove the horizontal louver
CN101 and CN102Slightly pull down the hinge area, deflect the louver, and
unhook it from the hinge. Remove the shaft from each of
the left and right sides.
5. Remove 2 connectors.
< AY-XPM7CR/9CR/12CR only >
< AY-XPM7CR/9CR/12CR only >
How to remove the HI VOLTAGE UNIT.
6. Pull the board.
Drain pan and related1. Remove the HIGH VOLTAGE UNIT.
(Press and spread the hook, and HI VOLTAGE will be
ready for removal.)
< AY-XPM7CR/9CR/12CR only >
How to remove the DUST SENSOR, the THERMISTOR
and the GAS SENSOR.
GAS SENSOR
DUST SENSOR
1. Remove 3 screws fixing motors.
THERMISTOR
Drain Hose
Drain pan
Projection
Groove
Remove the DUST SENSOR, the THERMISTOR, and the
GAS SENSOR.
(Press and spread the hook,and GAS SENSOR will be
ready for removal)
< AY-XPM7CR/9CR/12CR only >
How to remove the display board unit 2.
To disconnedTo reconnect
2. Turn the cap area of the drain hose counterclockwise,1
and remove it from the drain pan.
2
During installation, turn the drain hose to the state of
the engagement position.
After reinstallation, verify that it is securely fastened.
display board unit2
The display board unit 2 is pushed in the direction of arrow
1 .
And it is made to slide in the direction of arrow 2 , and
remove.
66 |
ACEC
