CD-BK3100W
Mark position
(Assemble the mode big gear in this position.)
2804
MT IDLER GEAR FCHANGE BOX R
Note:
To assemble the mode
big gear, incline it,
bring it into contact with
the circumference and
42
put the center hole into
LIFT GEAR Aposition since the
hatched part of the main
base is overlapped with
45the circumference.
32
46
>ABS<33
C1
1047
37
44
LIFT GEAR C
11343843
41
36LIFT GEAR B< Importance >
MODE BIG GEARDirect the short tooth
toward the center.
Scale: 2 magnifications
MODE BIG GEAR Scale: 2 magnifications
LIFT GEAR A/B/C
ASSEMBLING POSITION
(A)(B)
GAP (0.3-1.5 mm)< Importance >
<Assembling method of lift gear>
After setting up the mode big gear in the
shown position, engage it with the STB gear A
(gear on the lower side) at the position (A),
and assemble them, turning it in the arrow direction
into the position (B). (The short tooth directs toward the
center of the mode big gear.)
Check the gap (C) after assembly.
If no gap is found, repeat the above procedure.
(C)
42
LIFT GEAR A43
LIFT GEAR B44
L
41LIFT GEAR C
MODE BIG GEAR
Figure 18
� 18 �
ACEC
