CD-CH1500H/CD-CH1500W
Speaker System
CP-RW5500H/CP-RW5500W
1. Woofer
2. Tweeter
3. Subwoofer
4. Subwoofer Terminals
5. Main Speaker Terminals
6. Bass Reflex Duct
1
24
5
3
6
OPERATION MANUAL
Setting the Clock
5Turn the jog dial to adjust the hour and within 2 minutes, press the
ENTER button.
When the 12-hour display is selected, "AM" will change automatically to "PM".
6Turn the jog dial to adjust the minutes and within 2 minutes, press
the ENTER button.
The hour will not advance even if minutes advance from "59" to "00".
The clock starts from "0" second. (Seconds are not displayed.) The time display
In this example, the clock is set for the 24-hour (0:00) display.will disappear after a few seconds.
1Press the ON/STAND-BY button to turn the power on.To confirm the time display:
2Press the MENU button.[When the unit is in the stand-by mode]
Press the DISPLAY button on the remote control. The
3Turn the jog dial to select "CLOCK" and within 10 seconds, presstime display will appear for about 3 seconds.
the ENTER button.
[When the power is on]
Press the MENU button. The time display will appear
for about 10 seconds.
Note:
"CLOCK" will appear or time will flash at the push of the DISPLAY button when the
4Turn the jog dial to select the 24-hour or 12-hour display and withinAC power supply is restored after a power failure or unplugging the unit. Reset the
2 minutes, press the ENTER button.clock as follows.
To reset the clock:
[When time is flashing]
1 Press the ON/STAND-BY button.
2 Press the MENU button.
"0:00"The 24-hour display will appear.3 Press the ENTER button.
(0:00 - 23:59)4 Perform "Setting the Clock" from step 5.
"AM 12:00"The 12-hour display will appear.
(AM 12:00 - PM 11:59)[When "CLOCK" appears]
"AM 0:00"The 12-hour display will appear.Perform "Setting the Clock" from the beginning.
(AM 0:00 - PM 11:59)
To change the 24-hour or 12-hour display:
Note that this can only be set when the unit is first installed or it has been reset.1 Clear all the programmed contents. [Refer to "Clearing all the memory (reset)".]
[Refer to "Clearing all the memory (reset)".]2 Perform "Setting the Clock" from the beginning.
� 8 � |
ACEC
