Precautions on battery use
8. NOTES FOR SERVICING
? Do not leave an exhausted battery in the equipment.
? Do not expose the battery to water or flame, and do not take it apart.
? Store batteries out of the reach of small children.(1) SL-SW BLINDER (4P/6P)
Notes for handling Lithium batteries:
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type recommended by the
manufacturer.(6P)(4P)
Dispose of used batteries according to the manufacture?s instructions.
It inserts so that it cuts, Key Top side.
and it may lack and a
part may come to the
Key Top side.
7. RESETTING THE UNIT
SLIDE SW UNIT
Strong impacts, exposure to electrical fields, of other unusual conditions
SL-SW MASK (S)
may render the unit inoperative, and pressing the keys will have no
SL-SW MASK (L)
effect. If this occurs, you will have to press the RESET switch on the
bottom of the unit. The RESET switch should be pressed only when:
? an abnormal event occurs and all keys are disabled.
? you install or replace the battery.
UPPER CASE
(2) PROTECTION TUBE
(2)-1.EL -2910R (AC7)
Insulate between the transformer and the AC cord connector with pro-
tection tubes (2 pcs x 2 positions).
Notes: ? Pressing the RESET switch will clear the stored tax rate andProtection tube (2 pcs)
other data stored in the memory.
Transformer
? Use only a ballpoint pen to press the RESET switch. Do not
Protection
use anything breakable or anything with a sharp tip, such as a
tube (2 pcs)
needle.
? After pressing the RESET switch, connect the power supply
plug to an outlet. Turn the power switch "ON" and check that
"0." is displayed.
EL-2910R RESETTING THE UNIT
- 4 - |
ACEC
