UX-510ATH
FO-1470TH
3Take the new film out of its package, and insert two of the gears7Insert the empty spool into the back of the compartment so that the
provided with the fax into the ends of the spool with film. Make suregear and the flange fit into the slots on the sides of the compartment.
that the two tabs on the gears fit properly into the slots in the ends of
the spool.YMake sure that the gear engages with the gear below it.
YDo not yet remove the band which holds the spools together.
8Wind the film slightly (rotate the gear on the right side of the empty
2 tabs
spool) so that there is no slack in the film. Make sure that both edges
4Hold the empty spool so that the end with only one slot is on the left,of the film wind onto the spool evenly.
and lower the spools into the front of the printing compartment. The
gears in the ends of the spool with film should fit into the slots on
each side of the printing compartment.
9Close the print compartment cover, making sure it clicks into place.
5Cut the band which holds the spools together with scissors, and re-
YCaution! Close the cover slowly to make sure it doesnOt pinch your
move it. Insert the remaining gear into the right end of the empty
fingers.
spool and the flange into the left end of the empty spool. Make sure
the tabs on the gear and the flange fit into the slots in the ends of the
spool (the gear has two tabs and the flange has one tab).
1 tab
Flange
2 tabs
Gear
FLoad paper in the paper tray and then press the following keys to
initialize the film.
Note: Paper must be loaded before the film can be initialized. To load
6Pull the empty spool toward the back of the compartment, unwind-paper, see Loading the Printing Paper.
ing the film as you pull.Display shows:START
FUNCTION
6
INITIALIZE FILM
When to replace the imaging film
Replace the imaging film when the display shows:
FILM END
Use the following imaging film, which is available from your dealer
or retailer: Sharp FO-15CR Imaging Film
YCaution! The text of documents printed with the imaging film is
visible on the used film. If confidential information has
been printed, dispose of the film appropriately.
1 � 5 |
ACEC
