UX-258TH
FO-475TH
[4] Error code table
1. Communication error code table
G3 Transmission
CodeFinal received signalError Condition (Receiver side)
0Incomplete signal frameCannot recognize bit stream after flag
1NSF, DISCannot recognize DCS signal by echo etc.
Cannot recognize NSS signal (FIF code etc)
2CFRDisconnects line during reception (carrier missing etc)
3FTTDisconnects line by fall back
4MCFDisconnects line during reception of multi page
Cannot recognize NSS, DCS signal in the case of mode change
5PIP or PINThe line is hung up without replying to telephone request from the receiving party.
6RTN or RTPCannot recognize NSS, DCS signal after transmit RTN or RTP signal.
7No signal or DCNNo response in receiver side or DCN signal received* (transmitter side)
8-Owing to error in some page the error could not be corrected although the specified number of
error retransmission was at tempted.
11-Error occurred after or while reception by the remote (receiving) machine was revealed to be
impossible.
12-Error occurred just after fallback.
13-Error occurred after a response to retransmission end command was received.
G3 Reception
CodeFinal received signalError Condition (Receiver side)
0Incomplete signal frameCannot recognize bit stream after flag
1NSS, DCSCannot recognize CFR or FTT signal
Disconnects line during transmission (line error)
2NSC, DTCCannot recognize NSS signal (FIF code etc)
3EOPCannot recognize MCF, PIP, PIN, RTN, RTP signal
4EOMCannot recognize MCF, PIP, PIN, RTN, RTP signal in the case of mode change
5MPSThe line is hung up without replying to communication request.
6PR1-QCannot recognize PIP, PIN signal in the case of TALK request
7No signal or DCNNo response in transmitter (cannot recognize DIS signal) or DCN signal received* (receiver side)
8-Error occurred upon completion of reception of all pages.
9-Error occurred when mode was changed or Transmission/Reception switching was performed.
10-Error occurred during partial page or physical page reception.
11-Error occurred after or during inquiry from the remote (transmitting) machine as to whether
reception is possible or not.
12-Error occurred during or just after fallback.
13-Error occurred after the retransmission end command was received.
2 � 18 |
ACEC
