Changing the operative direction
The operative direction of controls is factory-Adjusting the sound
set as shown below.
characteristics
To increase
You can adjust the bass, treble, balance, and
fader.
You can store the bass and treble levels
independently for each source.
1Select the item you want to adjust by
To decrease
pressing (SOUND) repeatedly.
Each time you press (SOUND), the item
If you need to mount the rotary commander onchanges as follows:
the right hand side of the steering column, you
BAS (bass) t TRE (treble) t BAL (left-right)
can reverse the operative direction.
t FAD (front-rear)
2Adjust the selected item by pressing
either side of (SEEK/AMS).
When adjusting with the rotary
commander, press (SOUND) and rotate the
VOL control.
Note
Adjust within three seconds after selecting the
item.
Press (SOUND) for two seconds while
pushing the VOL control.
Tip
Attenuating the sound
You can also change the operative direction of
these controls with the unit (see OChanging the
sound and display settings� on page 16).Press (ATT) on the rotary commander.
OATT-ON� flashes momentarily.
To restore the previous volume level, press
(ATT) again.
Tip
When the interface cable of a car telephone is
connected to the ATT lead, the unit decreases the
volume automatically when a telephone call comes
in (Telephone ATT function).
15 |
ACEC
