CDX-555RF/555XRF
SECTION 5
MECHANICAL ADJUSTMENT
Y Elevator Height (Address) Adjustment
Note:This adjustments is necessary when the system controller (IC201),Adjustment Method:
variable resistor (RV201), slider (R), slider (L),1. or chassis (ELLoad a disc maV)gazine, and place the set vertically as shown
was replaced for any repair.below.
2. Connect the regulated power supply, and turn the power on.
Connection:3. Press the DISC button on the wired remote commander (RM-
X80RF) and select DISC 5.power supply
(DC 14.4 V)4. At this time, if the elevator shaft does not position between
comb teeth A and B at addresses 5 and 6 as shown below,
adjust the following.
+5. Press repeatedly the DISC + and � buttons on the wired re-
GNDmote commander (RM-X80RF) so that the elevator shafts
moves from address 6 to address 5, or from 5 to 6. At this
time, adjust RV201 on the main board so that the elevator shaft
positions smoothly between comb teeth A and B.
6. Further, place the set horizontally and make same adjustment
as mentioned above.
7. After adjustment at addresses 5 to 6 is finished, check all op-
erations from addresses 1 to 10 with the set placed vertically
and horizontally respectively to confirm that the elevator shaft
positions in a range between comb teeth A to B.
POWER connector (CN303)
wired remote commander
(RM-X80RF)
compact disc changer
DISPLAY connector (CN302)
comb tooth at address 6comb tooth at address 6
elevator shaft
AA
elevator shaft
BB
comb tooth at address 5
comb tooth at address 5
OKNG
RV201
18 |
ACEC
