CDX-CA810X
Ver 1.1
Power requirements12 V DC car battery
(negative ground)CAUTION
DimensionsApprox. 178 � 50 � 180 mmUse of controls or adjustments or performance of procedures
(7 1/8 � 2 � 7 1/8 in.) (w/h/d)
other than those specified herein may result in hazardous
Mounting dimensionsApprox. 182 � 53 � 161 mm
radiation exposure.
(7 1/4 � 2 1/8 � 6 3/8 in.) (w/h/d)
MassApprox. 1.2 kg
(2 lb. 10 oz.)
If the optical pick-up block is defective, please replace the whole
Supplied accessoriesParts for installation and connections (1 set)
Front panel case (1)optical pick-up block.
Card remote commander RM-X118Never turn the semi-fixed resistor located at the side of optical
pick-up block.
Design and specifications are subject to change without
notice.
SERVICE NOTES
optical pick-up bk loc
NOTES ON SERVICE
The IC303 and the remote commander as well as the instruction
manual have been changed on the way of the production cycle.
Verify the serial number of the product when servicing.
TYPE A for the serial number 1699999 and lower
TYPE B for the serial number 1700000 and higher
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK
OR BASE UNIT
The laser diode in the optical pick-up block may suffer electrostatic
breakdown because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.semi-fixed resistor
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.TEST DISCS
The flexible board is easily damaged and should be handled withThis set can playback CD-R and CD-ROM discs. The following
care.test discs should be used to check the capability:
NOTES ON LASER DIODE EMISSION CHECKCD-R test disc TCD-R082LMT (Part No. J-2502-063-1)
The laser beam on this model is concentrated so as to be focused onCD-RW test disc TCD-W082L (Part No. J-2502-063-2)
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission, ob-Notes on CD-R/CD-RW discs
serve from more than 30 cm away from the objective lens.? You can play CD-Rs (recordable CDs)/CD-RWs (rewritable CDs)
designed for audio use on this unit.
Notes on Chip Component ReplacementLook for these marks to distinguish CD-Rs/CD-RWs for audio
? Never reuse a disconnected chip component.use.
? Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
These marks denote that a disc is not for audio use.
? Some CD-Rs/CD-RWs (depending on the equipment used for
its recording or the condition of the disc) may not play on this
unit.
?
? You cannot play a CD-R/a CD-RW that is not f.inalized
? A process necessary for a recorded CD-R/CD-RW disc to be
played on the audio CD player.
ATTENTION AU COMPOSANT AYANT RAPPORT
SAFETY-RELATED COMPONENT WARNING!! � LA S?CURIT?!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINELES COMPOSANTS IDENTIFI?S PAR UNE MARQUE 0 SUR LES
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND INDIAGRAMMES SCH?MATIQUES ET LA LISTE DES PIéCES
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.SONT CRITIQUES POUR LA S?CURIT? DE FONCTIONNEMENT.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSENE REMPLACER CES COMPOSANTS QUE PAR DES PIéCES
PA RT NUMBERS APPEAR AS SHOWN IN THIS MANUAL ORSONY DONT LES NUM?ROS SONT DONN?S DANS CE MANUEL
IN SUPPLEMENTS PUBLISHED BY SONY.OU DANS LES SUPPL?MENTS PUBLI?S PAR SONY.
2 |
ACEC
