Ver 1.1 2000. 08
DimensionsApprox. 178 � 50 � 182 mm
(7 1/8 � 2 � 7 1/4 in.)
(w/h/d)
Mounting dimensionsApprox. 182 � 53 � 163 mm
(7 1/4 � 2 1/8 � 6 1/2 in.)
(w/h/d)
MassApprox. 1.5 kg (3 lb. 1 oz.)
Supplied accessoriesCard remote commander
RM-X92 (CDX-M750)
RM-X95 (CDX-M700R)
Parts for installation and
connections (1 set)
Design and specifications are subject to change without
notice.
SERVICE NOTES
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCKUS, Canadian model:
OR BASE UNIT
The laser diode in the optical pick-up block may sufCAUTIONfer electrostatic
breakdown because of the potential difference generaUse of controls or adjustments or performance of procedurested by the
charged electrostatic load, etc. on clothing and the human bodother than those specified herein may result in hazardousy.
During repair, pay attention to electrostatic breakdoradiation exposure.wn and also use
the procedure in the printed matter which is included in the repair
parts.
If the optical pick-up block is defective, please replace the whole
The flexible board is easily damaged and should be handled with
care.optical pick-up block.
Never turn the semi-fixed resistor located at the side of optical
pick-up block.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-optical pick-up bk loc
up block. Therefore, when checking the laser diode emission, ob-
serve from more than 30 cm away from the objective lens.
Notes on Chip Component Replacement
" Never reuse a disconnected chip component.
" Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
semi-fixed resistor
AEP/UK model:
This product is classified as a CLASS 1 LASER PRODUCT.
This label is located on the bottom of the
chassis.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
This label is located on the drive unit's internal
chassis.
When replacing the chassis (T) of mechanism deck which have
the OCAUTION LABEL� attached, please be sure to put a new
CAUTION LABEL (3-223-913-11) to the chassis (T).
2 |
ACEC
