x Color is not uniform
? Degauss the monitor.* If you place equipment that generates a On-screen messages
magnetic field, such as a speaker, near the monitor, or if you change
the direction the monitor faces, color may lose uniformity.INFORMATION
x White does not look whiteOUT OF SCAN RANGE
Adjust the color temperature.
x Monitor buttons do not operate ( appears on the
1 If ?OUT OF SCAN RANGE? appears:
screen)
This indicates that the input signal is not supported by the monitor?s
If the control lock is set to ON, set it to OFF.
specifications. Refer to the following remedy:
Check that the video frequency range is within that specified for
x Letters and lines show red or blue shadows at the
the monitor. If you replaced an old monitor with this monitor,
edges
reconnect the old monitor and adjust the frequency range to the
Adjust the convergence.
following:
Horizontal: 30 - 70 kHz; Vertical: 48 - 120 Hz
x A hum is heard right after the power is turned on
This is the sound of the auto-degauss cycle. When the power is
1 If ?NO INPUT SIGNAL? appears:
turned on, the monitor is automatically degaussed for five seconds.
* If a second degauss cycle is needed, allow a minimum interval of This indicates that no input signal is present. Refer to the following
20 minutes for the best result. A humming noise may be heard, but this is remedies.
not a malfunction. Check that the video signal cable is properly connected and all
plugs are firmly seated in their sockets.
Check that the HD15 video input connector?s pins are not bent or
pushed in.
Check that the computer?s power is ?on.?
Check that the graphic board is completely seated in the proper
bus slot.
1 If ?MONITOR IS IN POWER SAVE MODE?
US
appears:
This indicates that the computer is in power saving mode. This
message is displayed only when your computer is in a power saving
mode and you press any one of the buttons on the monitor. Refer to
the following remedies.
Try pressing any key on the computer keyboard or moving the
mouse.
Check that the computer?s power is ?on.?
Check that the graphic board is completely seated in the proper
bus slot.
To display this monitor?s name, serial number, and
date of manufacture.
While the monitor is receiving a video signal, press and hold the
center of the MENU / OK button for more than five seconds to
display this monitor?s information box.
INFORMAT ION
MODEL : CPD- E240
SER NO: 1234567
MANUFACTURED : 2002-01
7 |
ACEC
