Technical FeaturesTroubleshooting
Before contacting technical support, refer to this section.
Preset and user modes
If thin lines appear on your screen
When the monitor receives an input signal, it automatically
matches the signal to one of the factory preset modes stored in the
(damper wires)
monito?s r memory to provide a high quality picture at the center of
the screen.(See Appendix for a list of the factory pTreset mohe lines yodes.) u are experiencing on your screen are normal for the
For input signals that do not match one of the factTorriy prnitreseton mon modes,itor and are not a malfunction. These are shadows
the digital Multiscan technology of this monitor froensurm tehs e dthaatmp a er wires used to stabilize the aperture grille and are
clear picture appears on the screen for any ti?s mingm iostn t nohe timconitoreable when t?hs be saccreenkground is light (usually
frequency range (horiz-ont 85 kHal: 30 z, vertic- 170 al: 48 Hz). white). The aperture grille is the essential element that makes a
If the picture is adjusted, the adjustment data iTsr stiniored atron pis a ctuuser re tube unique by allowing more light to reach the
mode and automatically recalled whenever the same iscrenputen, resigsultnal ing in a brighter, more detailed picture.
is received.
Damper wires
Note for Windows users
For Windows users, check your video board manual or the utility
program which comes with your graphic board and select the
highest available refresh rate to maximize monitor performance.
Power saving function
On-screen messages
This monitor meets the power-saving guidelines set by VESA,
If no picture appears on the screen, one of the following messages
ENERGY STAR, and NUTEK. If no signal is received by the
appears on the screen. To solve t?hTer pourblobe lem, see
monitor from the connected computer, the monitor will
symptoms and reme? odines page 13.
automatically reduce power consumption .as shown below
INFORMATION
Power mode Power consumption 1 (power)
indicator
OUT OF SCAN RANGEInput signal
normal d 115 Wgreencondition
operation
active off* d 3 Worange**
The input signal condition
power off0 W (Approx.)offOUT OF SCAN RANGE
indicates that the input signal is not sup?s ported by the monitor
* When your computer is in active off mode, MONITOR IS INspeci fications.
POWER SAVE MODE appears on the screen if you press anNOy b IuNttPUT SIGNALon
on the monitor. After a few seconds, the monitor enters the power
indicates that no input signal is present.
saving mode again.
MONITOR IS IN POWER SAVE MODE
** If the horizontal or vertical sync signal is received by the monitor, the
indicates that the computer is in power saving mode. This
power indicator lights in orange.
message is displayed only when your computer is in a power
saving mode and you press any one of the buttons on the monitor.
12 |
ACEC
