1-4. COLOR ELECTRONIC VIEWFINDER1. EVF Initial Data Input
SYSTEM ADJUSTMENTSModeCamera
(DCR-TR7000/TR7000E/TR7100E/TRV315)SubjectArbitrary
Adjustment PageD
Note 1:The back light (fluorescent tube) is driven by a high voltage AC
power supply. Therefore, do not touch the back light holder toAdjustment Address70 to 76, 78 to 7C
avoid electrical shock.
Note 2:When replacing the LCD unit, be careful to preAdjusting method:vent damages
caused by static electricity.1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, and input the data in the following table.
[Adjusting connector]Note:To write in the non-volatile memory (EEPROM), press the
Most of the measuring points for adjusting the viewfinder systemPAUSE button of the adjustment remote commander each time
are concentrated in CN910 of the VC-213 board.to set the data.
Connect the Measuring Instruments via the CPC-13 jig (J-6082-3) Select page: 0, address: 01, and set data: 00.
443-A).
AddressDataRemark
The following table shows the Pin No. and signal name of CN910.707AFixed data
Pin No.Signal NamePin No.Signal Name7190White balance adj.
1SWP11EVF VCO
7260White balance adj.
2AFC F012EVF VG
7348Fixed data
3BPF MONI13DV RF SWP745AFixed data
4RF AGC IN14RF IN7570VCO adj.
5PB RF15CAP FG76B0Backlight consumption current adj.
6REG GND16RF MON
78D1Fixed data
7RF AGC OUT17TMS79ACFixed data
8VC RF SWP18TCK7A60Bright adj.
9EVF BL19TDO7B70Contrast adj.
10EVF BL 4.6V20TDI
7C90Backlight consumption current adj.
Table 5-1-9.
CN910
1
20
Screw driver (�)
Cover
Fig. 5-1-14
5-31 |
ACEC
