DSC-D700 (UC,CE)
Locking the Focus
10Turning the power/mode dial to OFF turns the
10YOFFpower off.
YCAMWhen you focus the picture by pressing the release button halfway, the focus is set at that distance
YPLAYuntil you release the button. This is called Focus Lock. If you want to take a picture of a subject on
MENUNotethe edge of the picture composition, engaging Focus Lock allows you to move the camera and then
If you do not operate the camera for about onetake the picture.
EXCUTE
minute when the camera is on in the CAM mode,
the LCD monitor automatically shuts off (Standby
EXIT1Center the subject in the viewfinder and press the
Mode).
release button halfway.
Also, if the camera is not touched for
Taking a PictureThe focus is fixed.Taking a Picture
approximately four minutes after that, the camera
automatically shuts completely off.1~3
EV
Auto FocusALDRIVEWBQUSIZEAEISOUSER
AE-LOCKR-REVIEW
This camera employs an auto focus mechanism. When auto focus is turned on, the camera
automatically focuses on the picture subject. Auto focus is turned on by setting the focus mode
switch to AF. Centering the AF frame on the subject and pressing the release button halfway focuses
the picture frame.
2Move the camera to frame the composition you
When the picture is in focus, the AF focusing mark in the LCD monitor and viewfinder changes aswant.
follows. Check the mark before making the exposure, and if the picture is not in focus, let go of the
release button and press it halfway again to refocus.
Y On the LCD monitor
When the picture is focused, the indicator lights a
When the release button is pressed halfway,steady green. If the picture cannot be focused, the
the AF focusing mark flashes green.indicator lights a steady red.
3Press the release button down completely.
Note
AE-LOCK
When you press the release button halfway to set
the focus, the exposure value is also set. This is
indicated by the AE-LOCK indicator in the
viewfinder and by highlighted display of the
Y In the viewfinderexposure value and shutter speed on the LCD
monitor.
When the release button is pressed halfway,When the picture is focused, theAlso, if you frame a subject that you'd like to
the AF focusing mark flashes.
indicator lights steadily.manually set the exposure for and press the AE-
2000 5.62000 5.6LOCK button, the exposure for that subject is
fixed.
When the picture cannot be focused,Use this function when it is necessary to change
the indicator continues flashing.the picture composition after deciding the
exposure. This is effective for picture taking
2000 5.6
under such conditions as where there is backlight.
To cancel AE-Lock, press the AE-LOCK button
again, or press any other operation button.
GBGB
1-1936 37 |
ACEC
