Y METHOD FOR COPYING OR ERASING THE DATA IN INTERNAL MEMORY
The data can be copied/erased by the operations on the Setup screen. (When erasing the damory.)ta, execute formatting the internal me
Note: 1When replacing the SY-127 board, erase the data in internal memory of the board before replacement.
Note: 2When replacing the SY-127 board or the IC381 on the SY-127 board, execute formatting and initialize the internal memory after
replacement.
Method for Copying the Data in Internal Memory
Copy
Copies all images in the internal memory to a OMemory Stick�.
OKSee the following procedure.
CancelCancels the copying.
1 Insert a OMemory Stick� having 32 MB or larger capacity.
2 Select [OK] vwi on theth control button,z the.n press
The message OAll data in internal memory will be copied Ready?� appears.
3 Select [OK] v wi, thth en przes. s
Copying starts.
Copying
102_COPY
Use batteries with enough capacity or the AC Adaptor (not supplied). If you attempt to copy image files
using batteries with little remaining capacity, the batteries may run out, causing copying to fail or possibly
corrupting the data.
You cannot copy individual images.
The original images in the internal memory are retained even after copying. To delete the contents of the
internal memory, remove the OMemory Stick� after copying, then execute the [Format] command in
Internal Memory Tool.
You cannot select a folder copied on a OMemory Stick�.
The setting of (Print order) marks is not copied even when you copy data.
Method for Formatting the Internal Memory
Format
Formats the internal memory.
Note that formatting irrevocably erases all data in the internal memory, including even protected images.
OKSee the followinedure.g proc
CancelCancels the formatting.
1 Select [OK] vwith on the control button, then press z.
The message OAll data in internal memory will be erased Ready?� appears.
2 Select [OK] vwith , then przess .
The format is complete.
Y PROCESS AFTER FIXING FLASH ERROR
When OFLASH error� (Self-diagnosis Code E : 91 : ** ) occurs, to prevent any abnormal situang of thetion caused by high voltage, setti
flash is changed automatically to disabling charge and flash setting.
After fixing, this setting needs to be deactivated. Flash error code can be initialized by the operations on the Setup screen.
Method for Initializing the Flash Error Code
Initialize
Initializes the setting to the default setting.
OKSee the following procedure.
CancelCancels the resetting.
1 Select [OK] vwith on the control b utton,z .then press
The message OInitialize all settings Ready?� appears.
2 Select [OK] vwith, then prze.ss
The settings are reset to the default setting.
Make sure that the power is not disconnected during resetting.
DSC-H1
1-3E |
ACEC
