3-16.TG2/7 ARM BLOCK, TG2/7 BAND BLOCK AND TENSION COIL SPRING (TG2)/(TG7)
Disassembly: Remove them in order of 1,2,3,4
For the disassembling and assembling procedures of the assembNotes during wlorky
components of the TG2/TG7 arm, refer to page 5-22.Be careful when handling the TG arm and the peripheral parts.
Y Twisting and bending of the band block and tension coil spring
Be careful not to touch
Y Dirt and scratches of the tape guide
the tape guide ( part) and TG band block.
Y Loss of the compression coil spring (TG)
Stop washer3
Compression Stop washerDo not reuse removed stop washers.
coil spring (TG) TG2 arm 3Stop washer
2
assembly
24Compression coil
Stop washerspring (TG)Disassembly of the band TG2/TG7 assembly
4TG7 arm assemblyWhen pulling porEtion of the TG2 or TG7 band in the
direction of the arrow, a click sound is heard as the
1
band is removed. To attach the bands, pull out the
Tension coil
opposite side to porE to loction k.
spring (TG7)
Tension coil 1
spring (TG2)
Band TG2/TG7 assemblyE
Shaft A
Shaft
Fig. 2
Shaft CShaft B
Shaft D
Fig. 1
Assembly: Attach them while referring to figure abo1 Apply grease to the top side of the fveA or Bixing shaft () of
or below and the descriptions.the TG arm. (Fig. 1)
When these parts are replaced or attached, perform each adjust-
ment from Adjustment Start -3 of the flowchart on page 5-23.Half size of one grain of rice
Hook each spring on
2 Attach the TG band assembly to the TG arm assembly. (Fig. 2)
the second hook from above
Be sure that the felt sides of the TG band face toward the reel
tables so that they surround the respective reel tables.
3 Attach the tension coil spring to the TG arm assembly. (Fig. 3,
4)
YHook the spring of the tension coil spring (TG2) from the
G
Finside and put it under the TG band. (FF, 4)ig. 3-
YHook the spring of the tension coil spring (TG7) from the
outside and put it under the TG7 band. (Fig. 3-G, 4)
Sub-slider
D4 Attach the TG arm block to the shaft (A or B) and attach the
HCtension coil spring to the second hook. When attaching the TG2
arm, the part must be at the left of porH of the slidertion .
(Fig. 3)
5 Attach the adjuster of the TG band to shafts C and D.
Fig. 3
Fixing shaft C or D
[TG2 side][TG7 side]
GoodNot good
This part also must be
inserted into the shaft.
Fig. 4
6 Fix the TG band and TG arm with new stop washers. When
Hook the spring from the inside Hook the spring from the outside attaching the TG arm, do not forget to attach the compression
and put it under the TG band.and put it under the arm.coil spring (TG). (Fig. 1)
5-16 |
ACEC
