4. SACD6-5. DRIVE MANUAL OPERATION
Select [4], insert SACD disc, and press [ENTER] key, and the
On the Test Mode Menu screen, select [2], and the manual opera-
adjustment will be made through the following steps, then adjustedtion menu will be displayed. For the manual operation, each servo
values will be written to the EEPROM. However, if SACD disc ison/off control and adjustment can be executed manually.
not available, use the player with initial data, skipping the SACD
adjustment. In this case, you can finish the adjustment if pressing## Drive Manual Operation ##
the [STOP] button.
Operation Menu
SACD Adjustment Steps1. Disc type
1. Sled Tilt Reset2. Servo Control
3. Track/Layer Jump
2. Set Disc Type CD4. Manual Adjustment
3. LD ON
4. Spdl Start5. Auto Adjustment
6. Memory Check
5. Wait 500 msec
6. Focus Servo ON 00. Disc Check Memory
7. Auto track Offset Adjust
8.Exit: Return
9. CLVA ON
10. Wait 500 msecIn using the manual operation menu, take care of the following
11. Tracking ONpoints. These commands do not provide protection, thus requiring
12. Wait 1 seccorrect operation. The sector address or time code field is dis-
13. Sled ONplayed when a disc is loaded.
14. Check CLV ON
15. Auto Focus Offset Adjust1. Set correctly the disc type to be used on the Disc Type
17.screen.
18. Auto Focus Gain AdjustThe disc type must be set after a disc was loaded.
19. Auto Focus Offset AdjustThe set disc type is cleared when the tray is opened.
20. Eq Boost Adjust2. After power ON, if the Drive Manual Operation was se-
21. Auto LFO Adjustlected, first perform OReset SLED TILT� by opening 1.
22. Auto Track Gain AdjustDisc Type screen.
3. In case of an alarm, immediatel[STOP]y press the but-
23. 32Tj Fwdton to stop the servo operation, and turn the power OFF.
24. 32Tj Rev
25. 500Tj FwdBasic operation (controllable from front panel or remote com-
26. 500Tj Revmander)
27. All Servo Stop */[POWER]Power OFF
[STOP]Servo stop
[OPEN/CLOSE]Stop+Eject/Loading
[RETURN]Return to Operation Menu or Test Mode
Menu
[NEXT], [PREV]Transition between sub modes of menu
[1] to [9], [0]Selection of menu items
Cursor UP/DOWN Increase/Decrease in manually adjusted
value
6-7 |
ACEC
