HCD-GNX60/GNX70/GX9900
SECTION 1
SERVICING NOTES
NOTES ON HANDLING THE OPTICAL PICK-UP BLOCKY MODEL IDENTIFICATION
OR BASE UNIT� Back Panel �
PART No.
The laser diode in the optical pick-up block may suffer electrostatic
break-down because of the potential difference generated by the
charged electrostatic load, etc. on clothing and the human body.
During repair, pay attention to electrostatic break-down and also
use the procedure in the printed matter which is included in the
repair parts.
The flexible board is easily damaged and should be handled with
care.
NOTES ON LASER DIODE EMISSION CHECK
The laser beam on this model is concentrated so as to be focused on
the disc reflective surface by the objective lens in the optical pick-
up block. Therefore, when checking the laser diode emission,
observe from more than 30 cm away from the objective lens.
LASER DIODE AND FOCUS SEARCH OPERATION
CHECKMODELPART No.
Carry out the OS curve check� in OCD section adjustment� and checkGNX60: E2, E3 models2-547-454-0[]
that the S curve waveform is output several times.GNX70: E2, E3 models2-547-456-0[]
GX9900 model2-547-458-0[]
GNX60: AR model2-588-965-0[]
GNX60: E51 model2-588-966-0[]
GNX70: AUS model2-588-967-0[]
GNX70: E51 model2-588-968-0[]
GNX60: AUS model2-588-974-0[]
YAbbreviation
AR : Argentine model
E2 : 120 V AC Area in E model
E3 : 240 V AC Area in E model
E51 : Chilean and Peruvian model
AUS: Australian model
4 |
ACEC
