Tape player section
Recording system4-track 2-channel stereo
Frequency response40 ? 13,000 Hz (?3 dB),
using Sony TYPE I
cassette
Tuner section
FM stereo, FM/AM superheterodyne tuner
FM tuner section
Tuning range
Tourist model:76.0 ? 108.0 MHz
Other models:87.5 ? 108.0 MHz
AntennaFM lead antenna
Antenna terminals75 ohm unbalanced
Intermediate frequency10.7 MHz
AM tuner section
Tuning range
Middle Eastern model:531 ? 1,602 kHz
(with the interval set at
9 kHz)
Other models:531 ? 1,602 kHz
(with the interval set at
9 kHz)
530 ? 1,710 kHz
(with the interval set at
10 kHz)
AntennaAM loop antenna
Antenna terminalsExternal antenna terminal
Intermediate frequency450 kHz
General
Power requirements
Thai model:220 V AC, 50/60 Hz
Other models:120 V, 220 V or
230 ? 240 V AC, 50/60 Hz
Adjustable with voltage
selector
Power consumption190 watts
Dimensions (w/h/d)Approx. 280 x 325 x 403 mm
MassApprox. 8.9 kg
Supplied accessories:AM loop antenna (1)
FM lead antenna (1)
Remote Commander (1)
Batteries (2)
Video cable (1)
Front speaker pads (8)
SAFETY-RELATED COMPONENT WARNING!!
Design and specifications are subject to change
without notice.
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITH
MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN THE PARTS
LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
SAFETY CHECK-OUT
After correcting the original service problem, perform the following safety
checks before releasing the set to the customer.
1.Check the area of your repair for unsoldered or poorly-soldered5.Check the B+ voltage to see it is at the values specified.
connections. Check the entire board surface for solder splashes6.Flexible Circuit Board Repairing
and bridges.Y Keep the temperature of the soldering iron around 270C
2.Check the interboard wiring to ensure that no wires areduring repairing.
"pinched" or contact high-wattage resistors.Y Do not touch the soldering iron on the same conductor of the
3.Look for unauthorized replacement parts, particularlycircuit board (within 3 times).
transistors, that were installed during a previous reY Be careful not to apply force on the conductor when solderingpair. Point
them out to the customer and recommend their replacement.or unsoldering.
4.Look for parts which, through functioning, show obvious signs
of deterioration. Point them out to the customer and
recommend their replacement.
2 |
ACEC
