14AR22
DESCRIPTION OF SCHEMATIC DIAGRAM
NOTES:WAVEFORM MEASUREMENT CONDITIONS:
1. The unit of resistance "ohm" is omitted.1. Photographs taken on a standard gated color bar
(K=k& =1000& , M=M& )signal, the tint setting adjusted for proper color. The
2. All resistors are 1/16 watt, unless otherwise noted.wave shapes at the red, green and blue cathodes of
3. All capacitors are ? F, unless otherwise noted.the picture tube depend on the tint, color level and
(P=pF=??F)picture control.
4. (G) indicates ?2% tolerance may be used.2. indicates waveform check points (See chart,
5. indicates line isolated ground.waveforms are measured from point indicated to
6. indicates hot ground.chassis ground.)
VOLTAGE MEASUREMENT CONDITIONS:a AND SHADED ( ) COMPONENTS
1. All DC voltages are measured with DVM connected= SAFETY RELATED PARTS.
between points indicated and chassis ground, line'MARK= X-RAY RELATED PARTS.
voltage set at 120V AC and all controls set for normal
picture unless otherwise indicated.This circuit diagram is a standard one, printed circuits
2. All voltages measured with 1000? V B & W or Colormay be subject to change for product improvement
signal.without prior notice.
WAVEFORMS
1 1.0 Vp-p2 2.8 Vp-p3 2.6 Vp-p4 2.7 Vp-p5 65.0 Vp-p
Horiz. RateHoriz. RateHoriz. RateHoriz. RateHoriz. Rate
6 67.0 Vp-p7 80.0 Vp-p8 3.0 Vp-p9 2.3 Vp-p0 116.0 Vp-p
Horiz. RateHoriz. RateVert. RateHoriz. RateHoriz. Rate
q 8.4 Vp-pw 40.8 Vp-pe 98.0 Vp-pr 1,160 Vp-pt 415.0 Vp-p
Horiz. RateVert. RateHoriz. RateHoriz. RatePower Supply Rate
15 |
ACEC
