(2) Move and align carriage 1 with the cutout sec-
Cutout section
Cutout section
tion of the frame, then unhook the wire fixture
..... (each screws for the front and rear).
(3) Remove the power supply cable from the car-
riage 2Os cable guide.
Carriage 1
View as seen from the exit side
(4) Slanting the whole carriage 1 unit, take it out
upwards.
Note:Be careful not allow the unit to get hitched
by the wire.
7.3.8Carriage drive wire
The same procedure applies for removing the front
Cutout section
Cutout section
and rear wires.
(1) Remove the original glass, top cover, right-
side cover (upper), left-side cover (upper), in-
ner cover, and control panel.
(2) Remove carriage 1 and the wire fixture
....... (each screw for the front and rear).
Note:Be careful not to get hitched by the wire.
Carriage 1
Mar. 1998 ? TOSHIBA7 - 111550/1560 OPTICAL |