CONVERGENCE ADJUSTMENT
Adjust convergence from center to circumference in order.1. Select the adjustment mode following the steps on page
9.
KEY FUNCTION IN THE CONVERGENCE ADJUSTMENT:
RCUT
Lord BACK UP DATA:1 button40H
Up :2 button
Selet Green color:3 button
Left :4 button
Blinking of cursor ON/OFF:5 button
Right:6 button
Adjust mode ON/OFF:7 buttonGENERAL ADJUSTMENTS
Down:8 button
Vertical stripe ON/OFF9 button
2. Press O7� button to display the built-in cross-hatch pattern
Erase Green line:0 buttonand press "9" button to display the vertical stripes.
Erase Red line:100 button3. If there is need to load BACKUP DATA, push "1" button,
Erase Blue line:ENT button
and then push "ENTER" button according to following
message. Convergence become adjusted state at factory
Note:
Adjusting procedure in replacing convergence board.by this action.
If there is no need, pass this process.
1. User convergence center check. Make sure the bestNever to use this function to new convergence board,
convergence setting is about the center of adjustable
range.because BACKUP DATA is not exist.
4. Adjustment around cursor can be done.
2. CENTERING ADJUSTMENTThe pattern includes three colors (R, G, B).
3. PICTURE POSITION ADJUSTMENT
The cursor should be blinking in Red.
4. HIT, WID ADJUSTMENTSPECIFIC INFORMATIONSThis means that the Red color is adjustable.
5. CONVERGENCE ADJUSTMENT5. Press O3� button to select Green color to be adjusted.
6. Execute TOUCH FOCUS following instructions displayed
6. Press O5� button to stop the blinking of cursor.
on the screen after finishing CONVERGENCE ADJUST-7. Press O2 (up)�, O8 (down)�, O4 (left)� or O6 (right)� to obtain
MENT.
7. If TOUCH FOCUS ERROR is displayed after finishingthe correct cross-hatch pattern as above.
If necessary, the specified color line can be erased from
TOUCH FOCUS, the method of CROSS-HATCH PAT-the screen.
TERN after CONVERGENCE adjustment is different from
what is exhibited on the right figure, or HARDWARE is out100 button ...................... to erase Red line
0 button ...................... to erase Green line
of order.CH RTN button ...................... to erase Blue line
8. Press O5� button to make the cursor blinking.
9. Press O2�, O8�, O4�, O6� buttons to move the cursor to other
point to be adjusted.
10. Repeat steps 6 to 9.
11. Repeat steps 5 to 10 to adjust Red and Blue colors.
Converge the selected color line into the Green line.
12. Press O7� button to memorize the adjusted states.
At this time, picture changes for about 1 second.
13. Press the TOUCH FOCUS button when "PLEASE PUSH
TOUCH FOCUS" is displayed on the screen.
14. TOUCH FOCUS CALIBRATION MODE is executed.
15. It returns to the normal screen after displaying
"CALIBRATION FINISHED".
� 13 � |
ACEC
