ADDING CHANNELS TO THE TV'S MEMORY
When you When you press Channel or , your TV will stop only on the channels stored in the TV's channel memory.
Follow the steps below and on the next page to program all active channels into the TV's memory.
Programming channels automaticallyAdding and erasing channels manually
Your TV can automatically detect all active channels in your After you have programmed the channels automatically, you
area and store them in its memory. After the channels are can manually add or erase specific channels.
stored automatically, you can manually add or erase To add or erase channels:
individual channels. To program channels automatically:
1Select the channel you want to add or erase. If you are
adding a channel, you must select the channel using the
Press MENU, and then press or until the SET UP
1Channel Number buttons.
menu appears.
Press MENU, and then press or until the SET UP
2
2Press or until the TV/CABLE is highlighted, and then menu appears.
press ENTER to display the pull-down menu.
3Press or to highlight ADD/ERASE, and then press
3Press or to highlight either TV or CABLE, depending ENTER to display the pull-down menu.
on which you use. If you use an antenna, highlight TV; if
4you use cable, highlight CABLE.Press or to select ADD or ERASE, depending on the
function you want to perform.
4Press ENTER.
5Repeat steps 1-4 for other channels you want to add or
5Press to select CH PROGRAM.erase.
6Press ENTER to start channel programming. The TV will
automatically cycle through all the TV or Cable channels
(depending on which you selected), and store all active
channels in the channel memory.
While the TV is cycling through the channels, the
message "Programming Now-Please Wait" appears.
7When channel programming is complete,the message
"Completed" appears.
8Press Channel or to view the programmed channels.
Note:
To tune the TV to a channel not programmed in the
channel memory, you must use the Channel Number
buttons on the remote control.
- 23 - |
ACEC
