Test Mode For Handset Unit
To perform the TEST mode, turn the power ON by pressing the ?? and ?#? buttons at the same time.
When entered the TEST mode, the bell rings and the unit enters TEST mode 1 . ( Refer to the following table. )
1. To change the TEST mode: Press the number key for the corresponding TEST mode.
(Refer to the following table)
2. To change channel:Press ?CH? key.
( Note: If the step is changed, the channel returns to the start channel. )
3. To cancel the TEST mode: Turn the power OFF, charge the Handset, or press the ?TALK? key.
STEPFUNCTIONKEYSTART CH TX CONTSCTX MUTE RX MUTE CONV REMARKS
1VCO/TX FREQ. ADJ121LHHLH
2TX MOD. CHECK221LHLLL
3TX DATA321LHLLL*1
4RX SENS421HHLHL
5SQ SENS521LHL*AL
6RECEIVE DATA CHECK621LHLLH*2
7BELL721HLLLH*3
8BATTERY LOW CHECK821HLLLH*4
9CHARGE CHECK921HLLLH*5
10DUPLEX021LHHHL
*A : Squelch ON is H, or Squelch OFF is L.
*1 : In the TEST mode 3, ?0000...? will be fed out continuously as transmitting data.
*2 : In the TEST mode 6, bell (1kHz) rings when the data received is ?0000...?.
*3 : In the TEST mode 7, bell rings with initial 2 tone (2kHz, 2.2kHz).
*4 : In the TEST mode 8, bell (1kHz) rings when P_BATLOW is ?L?.
*5 : In the TEST mode 9, bell rings when P_CHRGIN is ?L?.
Channel rotation
21 ? 20? 19? 40? 1 ? 2 ? 3 ? 4 ? 5 . . . . . . . . 37? 38? 39? 40
?
? 4 ? |
ACEC
