5 � RecordingNSync recording
3Begin playback on input source unit.If the sync level setting is too high, you may lose the
After playback is begun on input source unit, the Ţrst part of a song that begins softly.
CDR632 will start recording automatically when
it detects audio signal which is above the sync level
level adjusted in step 2. However, after Sync1 or Recording
starts
Sync ALL is selected, and if the signal below the
adjusted sync level is not detected over one sec-S_LEV
ENGLISHThis part of the track
ond, the CDR632 will not begin recording auto-
is not recorded
matically even it detects the audio signal.
leveltime
Start of recording
Conversely, you should be aware that if the sync level
setting is too low, the noise level of an analog source
may be higher than the sync level, so that sync S_LEV
noise levelrecording fails to start.
timelevel
Start of track is not registered
Noise is higher than
Notethreshold
In this manual, we refer to audio below the currently
speciŢed sync level as Osilence�.S_LEV
When Ţve seconds of silence occurs, the CDR632
will automatically enter record-ready mode. If you
selected OSync 1�, the sync recording setting will be time
defeated.
level
REC pauselevel
Division between tracks
5 seconds
S_LEV
S_LEV
Song you donOt
Song you want to recordwant to record
time
time
4To cancel sync recording, press the SYNC
REC button to select Sync OFF.
Note
Y If OSync 1� is selected, pressing the (pause) but-
ton will stop the disc and defeat the sync recording
setting.
Y If OSync ALL� is selected, pressing the (pause)
button will enter record-ready mode, but the sync
recording setting will be maintained.
Y In either case, the sync recording setting will be
defeated if you stop by pressing the (stop) button.
28 |
ACEC
