Wipes Using a BKDS-7370 Board
F8 (PAIR): Making the wipe like a venetian blind
KnobParameterSetting
1WidthWidth of strips (1 to 128)
2H OffsetInterval in the horizontal direction (�50.00 to +50.00)
3V OffsetInterval in the vertical direction (�50.00 to +50.00)
Changing the slit direction
Hold down the SHIFT button (the indication above F8 changes to
OSLIT�), and press F8 (SLIT). Select either of the following, to change
the direction.
H DIR: Horizontal direction
V DIR: Vertical direction
3Press F9 (MULTI).
The function key display changes as follows.
HVNON-MULTI
MULTIINVERTINVERTMASKPOS
OFFOFFOFFOFFOFF
F1F2F3F4F5F6F7F8F9F10
4Press the function key corresponding to the modifier you want to apply,
turning it on, and set the parameters.
F1 (MULTI): Use replicated patterns.
KnobParameterSetting
1H MultiNumber of pattern replications horizontally (1 to 63)
2V MultiNumber of pattern replications vartically (1 to 63)
3ShiftPosition of even-numbered rows with respect to odd-
numbered rows (�50.00 to +50.00)
F2 (H INVERT): When this is set to ON, alternate copies of the pattern
are reversed in the horizontal direction.
F3 (V INVERT): When this is set to ON, alternate copies of the pattern
are reversed in the vertical direction.
F4 (NON-MASK): When this is set to ON, then even if you move the
pattern with the positioner, an indefinite number of copies appear.
(The wipe always occurs with the number of copies of the pattern
specified with F1.)
4-172Chapter 4Basic Operations for Image Creation |
ACEC
