INSTALLATION
5) FIXING THE HOT PLATE- The prospective walls (left or right) that exceed the
The hot plate has a special seal which preventsworking table in height must be at a minimum
liquid from getting into the cabinet. Strictly complydistance from the cutting as mentionned both in
with the following instructions in order to correctlythe columns and the scheme.
- Fix the hob with the proper brackets OS� and fit the
apply this seal:prominent part into the porthole OH� on the bottom;
- Detach the seals from their backing, checking that
the transparent protection still adheres to the sealturn the screw OF� until the bracket OS� stick on the
top (fig. 12).
itself.- In order to avoid accidental touch with the
- Overturn the hot plate and correctly position seal
OE� (fig. 11) under the edge of the hot plate itself,overheating bottom of the hob, during the working,
so that the outer side of the seal perfectly matchesis necessary to put a wooden insert, fixed by
screws, at a minimum distance of 50mm from the
the outer edge of the hot plate. The ends of the
strips must fit together without overlapping.top (see fig. 9)
- Evenly and securely fix the seal to the hot plate,
Remark:Below is the suggested clearances. Actual
pressing into place with the fingers and remove the
strip of protective paper from the seal and set theinstallation will be veried subject to different kitchen
plate into the hole made in the cabinet.situations.
FIG. 11FIG. 12
9 |
ACEC
