ContentsReplacing the power supply lead
If the lead has to be replaced, only HO5RR-F or HO5RN-F type cables suitable for
the load and the operating temperature must be used.In addition, the yellow/greenFor the User
For Your Safety ........................................................................3earth wire must be about 2 cm longer than the live and neutral wires.
In all cases, the power supply lead must be positioned so that it does not reach a
°C above the room temperature in any point.Description of the hob ..............................................................6
Instructions for use...................................................................6One example of an ideal route is shown in the illustration.The cable is guided by
means of band clamps fixed to the side of the cabinet, in order to avoid any contact
with the appliance underneath the hob.Cleaning and maintenance ......................................................8
For the Installation Technician
Adapting to the different types of gas
Technical data ........................................................................12
Changing the nozzles
Instructions for the installation technician ..............................131) Remove the pan stands
2) Remove the burner caps and flame caps from theElectrical connection ..............................................................15
burners.
Adapting to the different types of gas.....................................16
3) Use a size 7 socket wrench to unscrew and remove
the nozzles, replacing them with those correspondingBuilding into fitted kitchen units..............................................17
to the type of gas to be used (see table).
4) Reassemble the parts, reversing the operations
described above.
5) Then replace the setting data plate (close to theGuide to reading the instructions
mains gas connection) with the one for the new type
The following symbols will help you whenof gas (it is in the bag of nozzles provided).
If the pressure of the gas used is different from that specified (or variable), a suitable
piped gas pressure regulator complying with the standard must be installed on thereading the instructions:
Safety information
"Step by step" instructions
Setting the minimum levelSuggestions and Advice
1) Light the burner as already described.
Information concerning environmental protection2) Turn the tap to the minimum flame position.
3) Remove the control knobs.A
4) Use a thin straight screwdriver to turn the by-pass pin located
next to the tap rod (see fig. A).If you are converting from naturalThis appliance complies with the following EEC Directives:
gas to LPG, turn the by-pass pin fully clockwise.- 73/23 and 90/683 (relating to Low Voltage);
The result should be a small, homogeneous flame which is- 89/336 (relating to Electromagnetic Compatibility);
uniform around the entire burner ring.- 90/396 (relating to Gas Appliances)
5) Finally, check that the burner does not go out when the tap is- 93/68 (relating to the General Standards)
turned quickly from the maximum to the minimum position.and subsequent amendments.
165 |
ACEC
