g
Cleaning and careClean the individual parts of the deep
3
fryer.
Unplug from the mains.
1 The lid(1), basket(3), oil/fat contai-
ner(5) and housing(6) can be washed
by hand or in the dishwasher. The long-
The fryer must be left to cool
1
life filter in the lid is automatically cle-
down for 60 minutes after frying.
aned at the same time. It should be
? After each use, wipe the housing and
ensured the lid with the long-life filter
lid with a soft, damp cloth to remove
is only reassembled when completely
splashes and spots of fat. Do not use
dry.
sharp objects or cleaners.
The control section(2) with the heater
? The deep fryer should be fully cleaned 1
element(4) must never be submerged
every time the oil is changed.
in water or held under running water.
Changing the oilIt should only be wiped with a damp
Small food particles often fall to the cloth.
bottom of the oil/fat container(5) ? After assembling the deep fryer, fill the
when frying. Since the heater ele-oil/fat container(5) with new oil or
ment(4) is above the base of the oil/fat melted fat.
container(5), these particles do not get Never mix new oil or fat with used,
stirred up the next time you use the always change all the oil or fat.
fryer; they remain at the bottom of the
container. It is sufficient to remove any
food remnants (e.g. with a metal sieve) Technical data
after each use.
Mains voltage:230V
Heating oil to more than 180°C for
2
Power consumption: 2000W
long periods reduces its quality. After
using 12 to 15 times or when the oil Maximum capacity: 3.5 litres of oil
foams unnaturally, change the oil as
follows:This appliance complies with the follo-
;
wing EC directives:
Removing the oil/fat contai-
? 73/23/EEC of 19/2/1973 "Low
ner(5)
voltage directive", including the
1. Press both the unlocking knobs simul-
modification directive 93/68/EEC.
taneously. Lid opens half way automa-
? 89/336/EEC of 3/5/1989 "EMC direc-
tically.
tive", including the modification
2. Open the lid fully, then tilt it slightly
directive 92/31/EEC.
until the hinge springs out of the
mounting on the control section(2).
Customer service
3. Remove the lid.
4. Take out the basket(3).The highest quality requirements are
placed on our appliances. Should,
5. Pull the control section(2) firmly
nevertheless, a malfunction occur on
upwards and off the retaining lugs on
which you can find no information in
the housing(6).
the operating instructions, please con-
6. Take the oil/fat container(5) out of the
tact your specialist dealer or AEG
housing.
Customer Service (addresses are on the
Tip the used oil out of the oil/fat con-next to last page).
2
tainer(5) into an appropriate container.
Never pour the oil into the sink or
down the drain.
10 |
ACEC
