Operating Instructions
What to do, if ...
Try to rectify minor faults on the dishwasher with the aid of the
instructions given here. If you call an engineer to resolve a of fault
listed here, or to repair a fault caused by incorrect use or installation, a
charge will be made even if the appliance is in guarantee.
...Error messages
If the programme indicator for the selected wash programme is
flashing and fault code (1 or (2 is displayed on the multi-display,
you can probably rectify the fault yourself.
After rectifying this fault, press the button for the wash programme
that has been started. The wash programme continues. If the fault
code is displayed again, contact customer service.
For all other faults, please contact customer service, stating the fault
code.
Symptom Possible Cause Solution
Fault code (1 is dis-Tap is closed. Open tap.
played on the multi-
The filter (where present) in
display. Clean the filter in the
the threaded hose fitting is
The programme indica-threaded hose fitting.
blocked.
tor for the selected
wash programme is
flashing:
The water inlet hose is not
there is no water run-Check hose installation.
correctly laid.
ning into the dish-
washer.
Fault code (2 is dis-The sink outlet is blocked. Clean the sink outlet.
played on the multi-
display.
The programme indica-
The water drain hose is not
tor for the selected Check hose installation.
correctly laid.
wash programme is
flashing.
Fault code (3 is dis-
The leak prevention system Close the tap and contact
played on the multi-
has been triggered. customer service.
display.
26 |
ACEC
