Troubleshooting
If you experience any of the following difficulties while using your player, use this
troubleshooting guide to help you to remedy the problem. Should any problem persist, consult
your nearest Aiwa dealer.
For trouble concerning operations while connected to your computer, also refer to
OTroubleshooting� in the separate manual for the OMusic Transfer pavit Edition� software.
Operation
SymptomCause/Remedy
There is no sound.c The volume level is set to the minimum level.
Increase the volume (page 10).
The buttons do not work.c The HOLD function is activated.
Release the HOLD function (page 14).
c The player contains moisture condensation.
Let your player sit for a few hours.
c The battery is exhausted.
Replace the battery with a new one (page 7).
The volume will notc The HOLD function is activated.
increase.Release the HOLD function (page 14).
The sound is distorted.c The bit rate used when encoding the MP3 files was low.
Transfer MP3 files encoded with higher bit rates to the Opavit.�Additional information
c The M.D.S.E function is turned on.
Turn off the M.D.S.E function (page 13).
Playback stops suddenly.c The battery is exhausted.
Replace the battery with a new one (page 7).
There is noise in thec The audio data itself contains noise.
playback sound.Noise may have been introduced when creating audio data due to
the conditions of the computer. Create the audio data again.
The LED indicator flashes redc The player is not functioning normally.
even though the battery hasRemove the Opavit� from the player and hold down Nx for more
just been replaced.than 5 seconds to reset the player.
c Send the audio data to the Opavit� again, as the data stored in the
Opavit� may have been destructed.
(Continued)
17 |
ACEC
