Adjusting soundSetting the clock
You can select the following modes for adjusting sound1Press and hold DISP until the clock indicator flashes
depending on the music you listen to: BASS (lowin the display.
frequencies), TRE (high frequencies), BAL (left/right),2Press TUNEi (to set hour) or TUNEk (to set
FAD (front/ rear) and H-BASS (high bass)minute) and turn the Smart Jog.
1Press SEL repeatedly to select the mode to be3Press DISP.
adjusted.
Pressing SEL cycles through the modes. TheDisplaying the clock
selected modeOs indicator flashes.
2Turn the Smart Jog to increase or decrease the level1Press DISP.
for the selected mode (except for H-BASS).To return to the former display, press DISP again.
In H-BASS mode, turn the Smart Jog to select on or
off.
RADIO OPERATION
Note
Adjust the level or select on/off within 5 seconds, or theTuning in to a station
selected mode will return to previous state.
(Seek/Manual Tuning)
Aligning the source levels
(Source Level Adjuster)
Volume may vary each time you change the source
mode. In this case, you can align each source modeOs
volume to almost the same level.
1Press FNC repeatedly to select the desired mode.
2Press DISP while pressing SEL.
OLA 0� appears in the display.Stereo indicatorLocal indicator
3Turn the Smart Jog to adjust the level.
Note
Adjust the level within 5 seconds, or the selected mode
will be canceled.
Band indicator Frequency indication
Restoring the factory settings
1Press FNC repeatedly to select the desired band
1Turn off the unit.
(FM1, FM2, FM3, AM1 or AM2).
2Press and hold DISP until OLA --� appears in the2*Press TUNEi (to move to higher frequencies) or
display.
TUNE k (to move to lower frequencies) to tune in to
a station.
Note
You can restore the factory settings only for VOL, BASS,OST� appears in the display when a station is
broadcasting in stereo, and receiving conditions are
TRE, BAL, FAD, and H-BASS, and aligned sourcegood.
volume levels.
*Seek Tuning and Manual Tuning
Y Press and hold TUNE i or TUNE k until seek Tuning
Muting button beep soundsstarts.
The unit locates a station automatically (Seek Tuning).
1Turn off the unit.Y Press TUNE i or TUNE k repeatedly to search for a
2Press and hold SEL until ObEEP� appears in thedesired station while increasing or decreasing the
display.frequency step by step (Manual Tuning).
3Turn the Smart Jog to select on (level indicatorsTo stop Seek Tuning, press TUNE i or TUNE k
appear) or off (level indicators disappear).again.
4Press and hold SEL until the unit turns off.
Monaural mode
When signals become weak, or reception becomes
poor, the unit automatically switches to Monaural mode
to reduce noise.
33 ENGLISH ENGLISH |
ACEC
