Adjusting sound
Setting the clock
You can select the following modes for adjusting sound
1Press and hold DISP until the clock indicator
depending on the music you listen to: BASS (low
flashes in the display.
frequencies), TRE (high frequencies), BAL (left/right),
FAD (front/ rear) and H-BASS (high bass).2Press i (to set hour) or k (to set minute), and
then turn AUDIO CONTROL .
1Press SEL repeatedly to select the mode to be3Press DISP.
adjusted.
Pressing SEL cycles through the modes. The
Displaying the clock
selected modeOs indicator flashes.
2Turn AUDIO CONTROL to increase/decrease the
1Press DISP.
level or to select on/off for the selected mode.
To return to the former display, press DISP again.
Note
Adjust the level or select on/off within 5 seconds, or the
selected mode will return to previous state.RADIO OPERATION
Tuning in to a station
Aligning the source levels
(Seek/Manual Tuning)
(Source Level Adjuster)
Volume may vary each time you change the sourceLO
mode. In this case, you can align each source modeOs
volume to almost the same level.
1Press SRC or BAND repeatedly to select the desired
mode.
2Press DISP while pressing SEL.
OLA 0� appears in the display.BAND
i/k
3Turn AUDIO CONTROL to adjust the level.
Stereo indicator Local indicator
Note
Adjust the level within 5 seconds, or the selected mode
will be canceled.
Restoring the factory settings
Band indicator Frequency indication
1Turn off the unit.
2Press and hold DISP until OLA --� appears in the1Press BAND repeatedly to select the desired band
display.(FM1, FM2, FM3, AM1, or AM2).
2*Press i (to move to higher frequencies) or k (to
Notemove to lower frequencies) to tune in to a station.
You can restore the factory settings only for VOL, BASS,OST� appears in the display when an FM station is
TRE, BAL, FAD, and H-BASS, and aligned sourcebroadcasting in stereo, and receiving conditions are
volume levels.good.
*Seek Tuning and Manual Tuning
Muting button beep soundsYPress and hold i or k until seek Tuning starts.
The unit locates a station automatically (Seek Tuning).
1Turn off the unit.YPress i or k repeatedly to search for a desired
2Press and hold SEL until ObEEP� appears in thestation while increasing or decreasing the frequency
display.step by step (Manual Tuning).
To stop Seek Tuning, press i or k again.
3Turn AUDIO CONTROL to select on (level indicators
appear) or off (level indicators disappear).
4Press SEL.
33 ENGLISH ENGLISH |
ACEC
