Adjusting sound
BASIC OPERATION,
AUDIO AND CLOCKYou can select the following modes for adjusting sound
depending on the music you listen to: BASS (low
ADJUSTMENTfrequencies), TRE (high frequencies), BAL (left/right),
FAD (front/rear), H-BASS (high bass)*, DSSA (Drivers
Sound Stage Adjustment)** and BBE***.
PWR/ATT
* You can reinforce the bass sound.
SEL** You can adjust sound stage and tone balance to best
Jog dial (PUSH-SOURCE)
serve a particular seat in the car.
*** You can enhance the clarity of high-frequency sound.
1Press SEL repeatedly to select the mode to be
adjusted.
Pressing SEL cycles through the modes. The
selected mode appears on the display.
DSPL TU (TUNER)2Turn Jog dial to increase or decrease the level for
+/-the selected mode (except for H-BASS, DSSA and
BBE).
Turning the unit on/off
In H-BASS mode, turn Jog dial to select 1, 2, 3 or
OFF.
YYou can turn the unit on by pressing any button on the
In DSSA mode, turn Jog dial to select L (for the front
front panel except z and %. The unit also turns on
left seat), R (for the front right seat) or OFF.
when you insert a CD.
In BBE mode, turn Jog dial to select 1, 2 or OFF.
YPress and hold PWR/ATT until the unit turns off.
Notes
Note
YAdjust the level or select an item within 5 seconds, or
Most operations described in this manual require the
the selected mode will return to previous state.
unit to be turned on before starting the operation,
YWhen DSSA is activated, you cannot adjust BAL and
unless explicitly stated otherwise.
FAD.
Changing the source mode
Aligning the source levels
1Press Jog dial (PUSH-SOURCE).(Source Level Adjuster)
Pressing Jog dial (PUSH-SOURCE) cycles through
Volume may vary each time you change the source
source modes in the following order:
mode. In this case, you can align each source modeOs
F1 (F2/F3/A1/A2) ? DISC* ? AUX INvolume to almost the same level.
?
1Press Jog dial (PUSH-SOURCE) or TU (TUNER)
*ODISC� does not appear on the display when there is
repeatedly to select the desired mode.
no CD in the unit.
2Press DSPL while pressing SEL.
OLEVEL 0� appears on the display.
Adjusting the volume3Turn Jog dial to adjust the level.
1Turn Jog dial.Note
OVOL (volume)� appears on theAdjust the level within 5 seconds, or the selected mode
display.will be canceled.
Muting the soundRestoring the factory settings
1Press PWR/ATT briefly.1Turn off the unit.
OATT ON� appears on the display.
2Press and hold DSPL until OLEVEL --� appears on
To restore volume, briefly press PWR/ATT again.
the display.
Note
You can restore the factory settings only for VOL, BASS,
TRE, BAL, FAD, H-BASS, DSSA and BBE, and aligned
source volume levels.
3 ENGLISH |
ACEC
