Replacing the battery
CARD REMOTE CONTROL
1Insert the tip of a pointed object A into the
Names of parts
hole B and pull out the battery holder to
remove the lithium battery (CR2025).
1DSPLMODE6
Remote control (back)
ALBUM +
+PRESET
2
SEEK-SOURCESEEK+7A
3
PRESET
-
ALBUM -B
4OFF+ATTVOL8Battery holder
5-
2Install a new lithium battery (CR2025)* with
the 3 side facing up in the battery holder,
and push the battery holder into the unit
until it clicks.
1 DSPL button
2 SOURCE button
3 SEEK (+/�) buttons
4 OFF button
5 VOL (+/�) buttons
6 MODE button
7 PRESET/ALBUM (+/�) buttons
8 ATT button* Use of any other battery may present a risk of
fire or explosion.
Note
If the display disappears by pressing (OFF) , itNote
cannot be operated with the remote control unlessWhen the infrared receptor on the main unit is
(SOURCE) on the unit is pressed, or a disc isexposed to direct sunlight, it may not respond to
inserted to activate the unit first.signals from the remote control.
PreparationsNotes on lithium battery
YKeep the lithium battery out of the reach of
A lithium battery is installed in the remote controlchildren. Should the battery be swallowed,
at the factory.immediately consult a doctor.
Before you use the remote control, be sure toYWipe the battery with a dry cloth to assure a
remove the insulating sheet by simply pulling itgood contact.
out.YBe sure to observe the correct polarity when
Remote control (back)
installing the battery.
YDo not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
WARNING
Insulating sheetBattery may explode if mistreated.
Do not recharge, disassemble, or dispose of in
fire.
11 |
ACEC
