Adjusting sound
BASIC OPERATION,
AUDIO AND CLOCKYou can select the following modes for adjusting sound
depending on the music you listen to: BASS (low
ADJUSTMENTfrequencies), TRE (high frequencies), BAL (left/right),
FAD (front/ rear) and H-BASS (high bass)
1Press SEL repeatedly to select the mode to be
adjusted.
Pressing SEL cycles through the modes. The
selected modeOs indicator flashes.
2Turn the Smart Jog to increase or decrease the level
for the selected mode (except for H-BASS).
In H-BASS mode, turn the Smart Jog to select on or
off.
Smart Jog
Note
Adjust the level or select on/off within 5 seconds, or the
Turning the unit on/offselected mode will return to previous state.
Y Press PWR/MUTE to turn on the unit. The unit also
turns on when you insert a CD.Aligning the source levels
Y Press and hold PWR/MUTE until the unit turns off.
(Source Level Adjuster)
NoteVolume may vary each time you change the source
Most operations described in this manual require themode. In this case, you can align each source modeOs
unit to be turned on before starting the operation, unlessvolume to almost the same level.
explicitly stated otherwise.1Press FNC repeatedly to select the desired mode.
2Press DISP while pressing SEL.
Changing the source modeOLA 0� appears in the display.
3Turn the Smart Jog to adjust the level.
1Press FNC.
Pressing FNC cycles through source modes in theNote
following order:Adjust the level within 5 seconds, or the selected mode
will be canceled.
Restoring the factory settings
* OCD� does not appear in the display when there is no
CD in the unit.1Turn off the unit.
2Press and hold DISP until OLA --� appears in the
display.
Adjusting the volume
1Turn the Smart Jog.Note
You can restore the factory settings only for VOL, BASS,
VOL (volume) indicator flashes.
TRE, BAL, FAD, and H-BASS, and aligned source
volume levels.
Muting the sound
1Press PWR/MUTE briefly.Muting button beep sounds
To restore volume, briefly press PWR/MUTE again.
1Turn off the unit.
2Press and hold SEL until ObEEP� appears in the
display.
3Turn the Smart Jog to select on (level indicators
appear) or off (level indicators disappear).
4Press and hold SEL until the unit turns off.
ENGLISH ENGLISH 22 |