Power supplyRemote control (CSD-TD30 only)
Using on AC house currentInsert two R6 (size AA) batteries.
Connect the AC cord as illustrated below.
R6 (AA)
When the reach of the remote control signal is less than
to the AC inlet of the unit5 meters (16 feet), replace the batteries.
supplied AC cord
to an AC outlet
(AC 120 V, 60 Hz)The remote control may not operate correctly
when:
CAUTION- The unit is exposed to intense light, such as direct
Use only the supplied AC cord. Use with other cordssunlight
may result in the risk of fire.-Objects block the remote control signal to the unit
To use the buttons on the remote control
Using on batteriesButtons on the remote control and the main unit with
identical indications have the same functions.
Open the lid of the battery compartment on the rear and
insert eight R14 (size C) batteries, not supplied, with
the 0 and 9 marks correctly aligned. Then close the
lid.
To switch from AC power supply to battery power
supply, disconnect the AC cord from the AC inlet.SOUND ADJUSTMENT
Volume or tone adjustment does not affect
recording.
VOLUME
Turn VOLUME to adjust.
R14 (C)
T-BASS system
When to replace the batteriesThe T-BASS system enhances the realism of low-
The tape speed slows down, volume decreases, orfrequency sound.
sound is distorted during operation.Set T-BASS to ON or OFF.
Notes on batteries
YDo not mix different types of batteries or old batteries
with new ones.
YWhen the unit is not to be used for a long period,
remove the batteries to prevent needless battery
wear.
YNever recharge the batteries, apply heat to them or
take them apart.
YRemove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to
remove.
4 ENGLISH |
ACEC
