TIMER OPERATIONS
5Press f or g to set the timer-activated
duration, then press SET.
POWERWith each press, the timer-activated duration changes in
5-minute steps between 5 to 240 minutes.
SLEEP
TONETIMER
POWER6Press f or g to adjust the volume for timer
6STANDBY/ONplayback, and press SET.
sThe volume level can be adjusted from 0 to 16.
Ensf,g
f,g7Prepare the source.SET
To play CD, load a disc.
SHIFT
To play a tape, insert the tape.
To play the radio, select the band and tune in the desired
station.
To play external equipment connected to the AUX IN jacks,
set an external timer for the equipment so that its playback
begins at the same time.
Sleep timerTimer playback
Turns off the unit automatically after a specified time.Turns on the unit at a specified time for the specified duration.8Press POWER 6STANDBY/ON (POWER) to turn
Make sure the clock is set correctly.the unit off.
1Hold down SHIFT and press SLEEP on the remote"5" remains on the display to indicate the timer standby
control.1Hold down SHIFT and press TIMER on the remote
mode.
"5" and "SLP" is displayed.control repeatedly so that "5" and "5 PLAY" is
At timer-on time, the unit turns on and plays the selected
displayed.source. After the specified timer-activated duration, the
2Within 6 seconds, press f or g repeatedly
to set the sleep timer duration.2Within 6 seconds, press SET.unit turns off again.
With each press, the timer duration changes in 5-minuteYTo stop timer setting in steps 3 to 6, press s.
3Press f or g to set the timer-on time, and
steps between 5 to 240 minutes. If there is no button inputTimer standby mode is also canceled.
press SET.
for 6 seconds, the current setting is entered automatically.YTimer playback will not begin unless the unit is turned off
Each press changes the time in 1-minute steps.
The unit turns off after the selected time.first.
Holding these buttons down will vary the time in 10-minute
YConnected equipment cannot be turned on or off by the built-
To check the remaining time until the unit turns offunits.
in timer of this unit. Use an external timer.
Hold down SHIFT and press SLEEP on the remote control.
4Press f or g to select the source, and press
The remaining time is displayed for 6 seconds.
SET.
To cancel the sleep timerYFor timer play of a CD, select "CD".
Hold down SHIFT and press SLEEP on the remote controlYFor timer play of a tape, select "TP".
repeatedly so that "SLP OFF" is displayed.YFor timer play of a radio broadcast, select "TU". You
will select the band later in step 7.
YFor timer play of the equipment connected to the AUX
IN jacks, select "AUX".
16 |
ACEC
