Display Angle AdjustmentAdjusting Volume/Balance
(Between Left and Right)/Fader
Movable display
(Between Front and Rear)
1Press the MODE button repeatedly to choose
the desired mode.
Each press changes the modes as follows:
The movable display may be adjusted to 3
different angles depending upon user preference.? VOLUME ? BALANCE ? FADER
1Press the F button, and when the FUNCNOTES
indicator blinks, adjust the movable display angle" If the MODE button is not pressed in 5 seconds after
selecting the BALANCE or FADER mode, the unit
by pressing button F1 (DOWN) or F2 (UP).automatically returns to the VOLUME mode.
NOTES" When the subwoofer mode is ON, its level may also be
" The display will close a half minute after the ignitionadjusted.
key is turned to the OFF position.
" The adjusted angle of the display is stored in memory.2Rotate the Audio Control knob until the desired
There is no need to re-adjust the angle when the power
is turned back on.sound is obtained in each mode.
NOTE
CAUTIONDepending on the connected devices, some functions and
Keep hands (or any other object) away from the displaydisplay indications do not work.
while it is opening or closing to avoid damage or injury.
The back of the movable display will get very warm under
normal operating conditions. This is not a malfunction. DoAdjusting Source Signal Level
not touch.
If the difference in volume level between the CD
Setting the Front Panel closing modeplayer and FM radio is too great, adjust the FM
signal level as follows.
1Press and hold the INTLZ button for at least 2
seconds.1Press and hold the INTLZ button for at least 2
seconds.
2Press the f UP button repeatedly to select
"CLOSE".2Press the f UP button repeatedly to select
Each press of the f UP button changes the"FM-LE. (FM-LEVEL)".
modes as shown:Each press of the f UP button scrolls the
modes as follows:
? FM-LE ? REG ? PTY31 ? AMBER ? DIM ? SUB ? BEEP
D-OUT ? CLOSE ? DEMO ? AUX ? SCR ? MUTE ?? FM-LE ? REG ? PTY31 ? AMBER ? DIM ? SUB ? BEEP
D-OUT ? CLOSE ? DEMO ? AUX ? SCR ? MUTE ?
NOTE
If you press the DN g button the display scrolls inNOTE
reverse sequence.When you press the DN g button, the display scrolls
in the reverse sequence.
3Press the TUNE button to toggle mode between
CLOSE AUTO and MANU.3Press the TUNE button to select the FM signal
" CLOSE AUTO: The Front Panel automaticallylevel mode. Each press toggles between "FM-
closes when ACC is on OFF.LEVEL HI" (High) and "FM-LEVEL LO" (Low).
" CLOSE MANU: The Front Panel remains open4Press and hold the INTLZ button for at least 2
until closed manually.seconds to activate the normal mode.
4When the setting is completed, press the INTLZ
button for at least 2 seconds to return to the
normal mode.
5-EN |
ACEC
