Basic
POWERBAND66666MODE / BBE
g DNf UP55555 SETUPANGLEc
Basic Operation
Turning Power On and OffSubwoofer On and Off
1Press the POWER button to turn on the unit.1Press and hold the SETUP button for at least 3
seconds.
NOTE
The unit can be turned on by pressing any other button
except the c button.2Press the g DN or f UP button to select
the SUB mode.The volume level gradually increases to the previous
level you were listening to before the unit was turned? FM LV ?? REG ?? SUB ?
off. Press the POWER button for more than 3? AUX ?? 100kHz/50kHz ?
seconds to turn off the unit.
NOTE
3Press the BAND button to select SUB-W ON orThe very first time the power is turned on, the volume will
SUBW OFF.start from level 12, the BBE will be on in the tuner mode.
4After setting is completed, press the SETUP
button to return to normal mode.
Display Angle AdjustmentNOTES
? Initial mode is "SUB-W ON."
Movable display? Set to "SUBW OFF" unless the subwoofer is used.
? When the subwoofer is turned on, the subwoofer
output level can be adjusted. For more details, refer
to the Adjusting Volume/Balance/Fader section on
page 7.
The movable display may be adjusted to 3
different angles depending upon user preference.
1Press the ANGLE button to adjust the angle of
the movable display.
NOTES
? The display will close a half minute after the ignition
key is turned to the OFF position.
? The adjusted angle of the display is stored in memory.
There is no need to re-adjust the angle when the
power is turned back on.
CAUTION
Keep hands (or any other object) away from the display
while it is opening or closing to avoid damage or injury.
The back of the movable display will get very warm
under normal operating conditions. This is not a
malfunction. Do not touch.
6-EN |
ACEC
